Evaporator Coil Repair in Austin, TX
We inspect frozen, leaking, and blocked evaporator coils in Austin.
Homeowners and tenants call us when “the AC runs but the air is warm,” “the line outside is frozen,” or “water is coming from the closet unit.” Those words often point toward the evaporator coil, the indoor heat-transfer coil behind the air filter and blower. We check the coil rather than assuming the thermostat, outdoor unit, or ductwork caused the change in cooling.
Other calls start with a damp air-handler cabinet, ice on the copper refrigerant line, weak airflow from supply vents, or a hissing sound near the indoor unit. A dirty filter, blocked condensate drain, failing blower, and refrigerant leak can overlap at the same air handler, so we inspect the parts in order before discussing a repair.
Evaporator coil trouble should not wait. Ice can restrict airflow, overflow from the drain pan can damage flooring or ceilings, and a leaking coil can leave the compressor operating with too little refrigerant for proper cooling.
Warm vents and water puddles
“Warm air from the vents” is one common report, especially when the thermostat keeps calling but the room temperature does not fall. “Ice on the copper pipe” is another, along with a frozen indoor coil behind the access panel. Some customers instead find a water puddle below the air-handler cabinet or hear a faint hiss after the blower stops.
Low airflow from several registers can also make a home feel warm even while the outdoor condenser runs. A wet drain pan may come from ice melting off the coil, while a coil leak can lower refrigerant charge and cause the coil to freeze. These clues can sound alike over the phone, but each points to a different part, repair path, and charge once we inspect the cabinet.
Air-handler inspection
We begin the callout at the indoor air handler by checking the filter, blower wheel, evaporator coil face, drain pan, condensate line, copper connections, and access panels. We record the model and serial information, then measure return and supply air temperatures and check refrigerant pressures at the service ports. A standard inspection commonly takes 30 to 60 minutes, although a coil covered in ice must thaw before we can see the fins and confirm a leak test result.
We can often clear accessible debris, replace a customer-supplied filter, or address a blocked drain path during the visit. If testing confirms a sealed-circuit leak, we recover refrigerant before opening the refrigerant lines, and we use the equipment rating to set the test pressure. A replacement coil usually needs another booking because the new coil must match the air-handler model, refrigerant type, metering device, and cabinet dimensions.
Cabinet access and coil age
Coil age affects the job because older air-handler models may use a discontinued coil or an earlier refrigerant design. A model with an available matched coil can move forward more directly than a cabinet that needs a special-order part. Corrosion across the aluminum fins, damaged copper bends, and several leak points can also change whether a localized repair makes sense compared with coil replacement.
Cabinet access matters as well. A coil behind a wide front panel and clear closet opening takes less preparation than one above a water heater, inside a tight attic platform, or behind built-in shelving. Refrigerant recovery, a restricted line-set route, a fabricated access panel, and an ordered coil all add labor or materials beyond a simple inspection.
Air-handler model plate
Before calling, check the model and serial plate on the air-handler cabinet and send a clear photo if you can reach it without removing a powered panel. The plate may sit behind a removable front door or on the side of the indoor cabinet. Tell us which room holds the air handler, whether the blower still runs, and whether you can see ice, water, or rust near the drain pan. Let us know if the closet, attic opening, or utility room has furniture, shelving, or other access limits. Call Air Conditioning Services Austin at (737) 300-9206, because a leaking evaporator coil can continue losing refrigerant and leave the compressor without the cooling it needs.
When we are open
Outside these hours, leave a message and we will call back.
Next: furnace repair, or back to the home page.
